EleCylinder 2-Finger Gripper
Flat grippers, vertical grippers & long-stroke grippers
The EleCylinder series has been completed with three universally applicable gripper types in 11 sizes. As with all EleCylinder actuators, the motor and controller unit are built-in and two positions can be set.
The new flat grippers are characterised by a low overall height of just 30 - 35 mm. This means that several can be mounted next to each other on a Z-axis for gripping workpieces of different sizes. Due to their design, vertical grippers are ideally suited for mounting on the Z-axis of multi-axis systems such as Cartesian robots or SCARA robots.
The new EleCylinder long-stroke grippers are available with a maximum stroke of 130 mm per side and a gripping force of up to 1,641 N.
Easy setting
All EleCylinder grippers are easy to set up in just four steps:
Step 1: Check "Thrust"
Step 2: Enter thrust force
Step 3: Setting the standby position
Step 4: Setting the thrust starting point
The precise numerical setting also enables easily deformable workpieces to be gripped.
Easy cable installation
All grippers require only one cable and have a 4-way cable outlet, which allows the cable to exit in four directions. An optional cable tie mount is available, resulting in a simple, stable cable installation.
Wireless programming
With the TB-03 teaching pendant, EleCylinder can be programmed wirelessly up to a range of approx. 5 metres. In addition to the basic settings, test runs, alarm settings and much more can be checked without a communication cable. Up to 16 actuators can be connected and adjusted in wireless mode, even in inaccessible systems.