EleCylinder stand-alone actuators
EleCylinders in slider type or rod type des design as well as radial cylinders are also available with an operating panel on the housing as standard. This means that no connection to a PC or teaching pendant device is necessary. notwendig.
All operating settings and test runs can be done from an operating panel on the EleCylinder body. No PC or teaching pendant device need to be connected.
Settings & test run
The start and stop position as well as acceleration, speed and deceleration are set on the operating panel.
For the test run, simply press the up and down buttons to move the drive forwards or backwards.
The complete EleCylinder series is optionally available with the “3-position mode specification”. This means that stops are not only possible at the set start and end positions, but also in between.
In certain applications, the cycle time can be shortened by stopping at intermediate positions.
Flyer | EC 3 Position Mode Option
Manual | EC 3 Position Configuration, Wiring & Operation
